!qdQjGbhD!iuywTLcb4t5Jq8Knby7_Kfez5HuET4AIfjzOKnoMQAY So that tells me that that ECU is working as it should, I shut the car off, plugged the connector back and started the car again and that message went away.Īs noted before I plan on checking the voltage to the connector for the correct reading to eliminate that, if it reads correct then it must be the sensor itself and I will have to pay to get the hub taken off and replaced. (my garage tool arsenal is not that vast!).įree download TOYOTA TIS Techstream V13.10.019 for Toyota customization: Once I did that I started the car to see what I got and I got the message of “Break Malfunction pull over immediately…” you know the message. Then I tried looking at the ABS ECU connectors but could not fully pull it and disconnect all the connectors and clean it, so I decided to pull the grey connector that sits on top of it. I opened the fuse box on the passenger side and checked all the fuses and they all seemed in tact none were blown. Last night I did not have time to jack up the car and put a multimeter to the wire harness connector at the ABS sensor, so I did some other troubleshooting.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |